Linux version 2.4.31 (root@rouge) (gcc version 3.3.4) #2 Mon Oct 24 21:58:19 JST 2005 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000001fff0000 (usable) BIOS-e820: 000000001fff0000 - 000000001fff3000 (ACPI NVS) BIOS-e820: 000000001fff3000 - 0000000020000000 (ACPI data) BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) 511MB LOWMEM available. On node 0 totalpages: 131056 zone(0): 4096 pages. zone(1): 126960 pages. zone(2): 0 pages. Kernel command line: auto BOOT_IMAGE=linux ro root=303 hdc=ide-scsi ide_setup: hdc=ide-scsi Initializing CPU#0 Detected 902.055 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 1795.68 BogoMIPS Memory: 515216k/524224k available (1550k kernel code, 8620k reserved, 589k data, 96k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Dentry cache hash table entries: 65536 (order: 7, 524288 bytes) Inode cache hash table entries: 32768 (order: 6, 262144 bytes) Mount cache hash table entries: 512 (order: 0, 4096 bytes) Buffer cache hash table entries: 32768 (order: 5, 131072 bytes) Page-cache hash table entries: 131072 (order: 7, 524288 bytes) CPU: L1 I Cache: 64K (32 bytes/line), D cache 64K (32 bytes/line) CPU: L2 Cache: 64K (32 bytes/line) CPU: After generic, caps: 00803135 80803035 00000000 00000000 CPU: Common caps: 00803135 80803035 00000000 00000000 CPU: Centaur VIA Ezra stepping 08 Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel PCI: PCI BIOS revision 2.10 entry at 0xfb380, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) PCI: Via IRQ fixup PCI: Using IRQ router VIA [1106/0596] at 00:07.0 Activating ISA DMA hang workarounds. isapnp: Scanning for PnP cards... isapnp: checksum for device 1 is not valid (0xf8) isapnp: Card 'UltraSound Plug & Play' isapnp: Card 'ESS Plug and Play AudioDrive' isapnp: 2 Plug & Play cards detected total Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16) longhaul: VIA C3 'Ezra' [C5C] CPU detected. Longhaul v1 supported. Starting kswapd Installing knfsd (copyright (C) 1996 okir@monad.swb.de). pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 Linux agpgart interface v0.99 (c) Jeff Hartmann agpgart: Maximum main memory to use for agp memory: 439M agpgart: Detected Via Apollo Pro chipset agpgart: AGP aperture is 64M @ 0xe0000000 Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: IDE controller at PCI slot 00:07.1 VP_IDE: chipset revision 16 VP_IDE: not 100% native mode: will probe irqs later VP_IDE: VIA vt82c596b (rev 23) IDE UDMA66 controller on pci00:07.1 ide0: BM-DMA at 0xd000-0xd007, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0xd008-0xd00f, BIOS settings: hdc:DMA, hdd:pio hda: Maxtor 4R080L0, ATA DISK drive blk: queue c03594a0, I/O limit 4095Mb (mask 0xffffffff) hdc: PIONEER DVD-RW DVR-105, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: attached ide-disk driver. hda: host protected area => 1 hda: 160086528 sectors (81964 MB) w/2048KiB Cache, CHS=9964/255/63, UDMA(66) hdc: attached ide-scsi driver. Partition check: hda: hda1 hda2 hda3 hda4 SCSI subsystem driver Revision: 1.00 scsi0 : SCSI host adapter emulation for IDE ATAPI devices Vendor: PIONEER Model: DVD-RW DVR-105 Rev: 1.33 Type: CD-ROM ANSI SCSI revision: 02 Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0 sr0: scsi3-mmc drive: 32x/32x writer cd/rw xa/form2 cdda tray Uniform CD-ROM driver Revision: 3.12 usb.c: registered new driver usbdevfs usb.c: registered new driver hub host/uhci.c: USB Universal Host Controller Interface driver v1.1 PCI: Found IRQ 9 for device 00:07.2 PCI: Sharing IRQ 9 with 00:0a.1 host/uhci.c: USB UHCI at I/O 0xd400, IRQ 9 usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected PCI: Found IRQ 9 for device 00:0a.0 host/uhci.c: USB UHCI at I/O 0xdc00, IRQ 9 usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 2 ports detected PCI: Found IRQ 9 for device 00:0a.1 PCI: Sharing IRQ 9 with 00:07.2 host/uhci.c: USB UHCI at I/O 0xe000, IRQ 9 usb.c: new USB bus registered, assigned bus number 3 hub.c: USB hub found hub.c: 2 ports detected Initializing Cryptographic API NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 4096 buckets, 32Kbytes TCP: Hash tables configured (established 32768 bind 65536) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. FAT: bogus logical sector size 44037 FAT: bogus logical sector size 44037 reiserfs: found format "3.6" with standard journal hub.c: new USB device 00:0a.0-1, assigned address 2 usb.c: USB device 2 (vend/prod 0x67b/0x2303) is not claimed by any active driver. reiserfs: checking transaction log (device ide0(3,3)) ... for (ide0(3,3)) ide0(3,3):Using r5 hash to sort names VFS: Mounted root (reiserfs filesystem) readonly. Freeing unused kernel memory: 96k freed Adding Swap: 755044k swap-space (priority -1) usb.c: registered new driver acm acm.c: v0.21:USB Abstract Control Model driver for USB modems and ISDN adapters natsemi dp8381x driver, version 1.07+LK1.0.17, Sep 27, 2002 originally by Donald Becker http://www.scyld.com/network/natsemi.html 2.4.x kernel port by Jeff Garzik, Tjeerd Mulder PCI: Found IRQ 9 for device 00:09.0 eth0: NatSemi DP8381[56] at 0xe092e000, XX:XX:XX:XX:XX:XX, IRQ 9. eth0: link up. eth0: Setting full-duplex based on negotiated link capability. usb.c: registered new driver serial usbserial.c: USB Serial support registered for Generic usbserial.c: USB Serial Driver core v1.4 usbserial.c: USB Serial support registered for PL-2303 usbserial.c: PL-2303 converter detected usbserial.c: PL-2303 converter now attached to ttyUSB0 (or usb/tts/0 for devfs) pl2303.c: Prolific PL2303 USB to serial adaptor driver v0.10.1