OpenBSD 5.4 (GENERIC) #37: Tue Jul 30 12:05:01 MDT 2013
    deraadt@i386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC
RTC BIOS diagnostic error 39<config_unit,memory_size,fixed_disk>
cpu0: Vortex86 SoC  (686-class) 301 MHz
cpu0: FPU,TSC,CX8,SEP,CMOV,MMX,PERF
real mem  = 133492736 (127MB)
avail mem = 119889920 (114MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 06/23/99, BIOS32 rev. 0 @ 0xfda65, SMBIOS rev. 2.7 @ 0x7fe1420 (6 entries)
bios0: vendor coreboot version "4.0-5047-ge573910" date 12/17/2013
bios0: DMP Vortex86EX
acpi at bios0 function 0x0 not configured
pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xf4200/224 (12 entries)
pcibios0: no compatible PCI ICU found: ICU vendor 0x17f3 product 0x6011
pcibios0: Warning, unable to fix up PCI interrupt routing
pcibios0: PCI bus #1 is the last bus
bios0: ROM list: 0xef000/0x1000!
cpu0 at mainbus0: (uniprocessor)
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 0 function 0 vendor "RDC", unknown product 0x6025 rev 0x01
ppb0 at pci0 dev 1 function 0 vendor "RDC", unknown product 0x1031 rev 0x02: irq 15
pci1 at ppb0 bus 1
pcib0 at pci0 dev 7 function 0 vendor "RDC", unknown product 0x6011 rev 0x01
pcib1 at pci0 dev 7 function 1 vendor "RDC", unknown product 0x6011 rev 0x01
vte0 at pci0 dev 8 function 0 "RDC R6040 Ethernet" rev 0x00: irq 9, address 00:1b:eb:62:eb:97
ukphy0 at vte0 phy 1: Generic IEEE 802.3u media interface, rev. 0: OUI 0x000bb4, model 0x0005
ohci0 at pci0 dev 10 function 0 "RDC R6060 USB" rev 0x13: irq 14, version 1.0, legacy support
ehci0 at pci0 dev 10 function 1 "RDC R6061 USB" rev 0x07: irq 10
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "RDC EHCI root hub" rev 2.00/1.00 addr 1
pciide0 at pci0 dev 12 function 0 vendor "RDC", unknown product 0x1012 rev 0x03: DMA (unsupported), channel 0 configured to native-PCI, channel 1 configured to native-PCI
pciide0: using irq 11 for native-PCI interrupt
wd0 at pciide0 channel 0 drive 0: <00000 D0 RDC SD-IDE HOST CONTROLLER>
wd0: 1-sector PIO, LBA, 3759MB, 7698432 sectors
pciide0: channel 1 ignored (not responding; disabled or no drives?)
azalia0 at pci0 dev 14 function 0 vendor "RDC", unknown product 0x3010 rev 0x02: irq 7
azalia0: No codecs found
vendor "RDC", unknown product 0x1060 (class serial bus subclass USB, rev 0x03) at pci0 dev 15 function 0 not configured
vendor "RDC", unknown product 0x1331 (class undefined unknown subclass 0xff, rev 0x00) at pci0 dev 16 function 0 not configured
vendor "RDC", unknown product 0x1710 (class undefined unknown subclass 0xff, rev 0x01) at pci0 dev 16 function 1 not configured
vendor "RDC", unknown product 0x1070 (class serial bus subclass CANbus, rev 0x00) at pci0 dev 17 function 0 not configured
isa0 at pcib0
isadma0 at isa0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
com2 at isa0 port 0x3e8/8 irq 5: ns16550a, 16 byte fifo
com3 at isa0 port 0x2e8/8 irq 12: ns16550a, 16 byte fifo
com3: console
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard
pcppi0 at isa0 port 0x61
spkr0 at pcppi0
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
pcic: does not support memory and I/O cards, ignored (ident=3)
pcic: does not support memory and I/O cards, ignored (ident=3)
pcic: does not support memory and I/O cards, ignored (ident=3)
pcic: does not support memory and I/O cards, ignored (ident=3)
isa at pcib1 not configured
usb1 at ohci0: USB revision 1.0
uhub1 at usb1 "RDC OHCI root hub" rev 1.00/1.00 addr 1
nvram: invalid checksum
vscsi0 at root
scsibus0 at vscsi0: 256 targets
softraid0 at root
scsibus1 at softraid0: 256 targets
root on wd0a (0797fdcd4bdb2b68.a) swap on wd0b dump on wd0b
clock: unknown CMOS layout